Publicidad
Idiomas disponibles
Idiomas disponibles
10
en
BATTERY INSTALLATION
Batteries must be inserted correctly to avoid damage to the radio. Always remove the
batteries when the radio will not be used for a long period of time, as this will cause
leakage to the batteries and subsequently damage to your device.
BATTERY INSTALLATION
Slide out cover and install
3 AA TYPE
batteries in
the numbered order,
making sure to match the
polarity markings inside
the compartment.
Note:
Make sure that the batteries had been installed over the ribbon inside the compartment.
•
When the batteries need to be replaced, pull the ribbon to remove the batteries
easily from the compartment.
BASIC OPERATION
TURNING ON THE RADIO
Press POWER ON/OFF button to
power on the unit (the display will
bright blue, and the word ON will
appear); press it again to power
OFF (standby mode) the radio (the
display will bright blue, and the
word "OFF" will appear).
KEY LOCK FUNCTION
Press and hold the DISPLAY /
button for two seconds to set the
key lock function.
Once the key lock function is
enabled, the keyboard of the radio
will be lock.
To disable the key lock function,
press and hold for two seconds
the DISPLAY /
button.
Note:
•
If you are unable to turn on the radio, please check that the batteries were installed
correctly, the battery capacity is sufficient and the lock function has not been turned on.
POWER
DISPLAY
0kHz
DISPLAY
[
]
USING THE ANTENNA
TIPS TO IMPROVE RECEPTION
A.
For FM/SW broadcasting:
In case of receiving FM/SW broadcasting, fully extend the telescopic antenna, and
adjust its length and direction to get a better reception.
B.
For MW/LW broadcasting:
There is magnetic antenna inside the radio. When receiving MW and LW broadcasting,
rotate the radio or change its location to achieve optimum reception.
Note:
The bottom of the antenna can be rotated and stretched.
•
TUNE INTO STATIONS
Press the POWER ON/OFF button to turn on your radio, then select your desired
band by pressing the FM, MW/LW, SW ( ) or ( ) button. Now, you can turn into your
favorite stations with any of the following tuning methods:
METHOD 1: ETM (EASY TUNING MODE)
ETM skillfully combines a reception circuit of high quality and high precision dial
for easy tuning radio stations.
Using ETM to auto tune and store all available stations into a temporary memory
without effecting ATS nor regular memories, please follow below steps:
Press the ETM button to
1.
enter on Easy Tuning Mode.
The display will show the
word ETM.
2.
Select your desired band, then
press and hold the ETM button
until the auto scan starts.
The auto scan function will
store all the avalible stations
in the ETM memory.
When the auto scan has
3.
stoped the searching, turn
the TUNING KNOB to select
those recently stored stations.
11
Publicidad
