Publicidad
Idiomas disponibles
Idiomas disponibles
3) Install the dirty water tank on the arm of the control handle.
4) Connect the pipes hooked to the control arm to the connectors on the cover of the dirty water tank.
5) Make sure the brush is properly installed.
Brush replacement:
Caution:
• Before installing/removing the brush, turn off the machine and make sure that the brush drive has
stopped rotating.
• Do not use any control button when someone is touching the brush. Possible injury.
a) Turn the control handle upright and lay the machine down on the floor. Then align the brush
with the three-blade plate and turn the brush counterclockwise. The assembly is complete.
b) If it is necessary to replace the brush, hold the brush and turn it clockwise to remove the
brush.
3.3.
Preparation for operation
Do not operate the machine under unfavorable conditions, such as an acidic/alkaline environment,
or an operating temperature lower than -10°C or above +35°C.
Preparation before starting the machine
Pour water into the cleaning solution tank
•
Open the clean water tank lid, then pour water or diluted neutral detergent into it.
The water temperature must not exceed 50 ° C.
•
Note
• To avoid shortening the service life of the machine, detergents added to the solution tank should
be low-foaming and low-volatile neutral detergents with a pH of 5-9.
• If detergents are used, a skimmer should be added to the dirty water tank to prevent dirt foam
from entering the engine and damaging it. The manufacturer is not responsible for damage to the
suction motor caused by the lack of an anti-foaming agent.
Charging the battery
Publicidad
