Publicidad
Idiomas disponibles
Idiomas disponibles
36 " GAS RANGE INSTALLATION INSTRUCTIONS
10. Anti-tip Bracket Installation
Important Safety Warning
This range must be properly secured to the floor
by using the included anti-tip brackets and screws.
Failure to install the brackets could allow the range
to accidentally tip over if excessive weight is placed
on an open door or if a child climbs upon it. Serious
injury might result from spilled hot liquids or from the
range itself. Refer to the instructions below for proper
installation (Figure 10).
NOTE: If the range is ever moved to a different
location, the anti-tip brackets must also be moved and
installed with the range.
The anti-tip kit is located in a plastic bag in the
oven.
Tools Required:
5/16" Nutdriver or Flat Head Screwdriver
Adjustable Wrench
3/16" Dia. Masonry Drill Bit (if installing in concrete)
Attach brackets to the floor at the back of the range
to hold both rear leg levelers. When fastening to the
floor, be sure that screws do not penetrate electrical
wiring or plumbing. The screws provided will work in
either wood or concrete.
Range may be anchored to floor in a house with hold
down brackets as illustrated in Figure 10. These hold
down brackets allow range to be freely pulled out from
the wall for cleaning or servicing without the use of
tools.
1. Attach brackets to the floor or rear wall with screws
provided. Important: Attachment must be secured
to solid floor or wall. Do not attach to plaster, sheet
rock, or other soft material. If attachment is to rear
wall, any moldings must be removed in area behind
range.
2. If brackets are to be attached to masonry or
ceramic floors, position brackets on floor and mark
hole location. Drill 3/16" holes.
3. Lower both rear leg levelers about three turns so
the brackets will slide over leveler head.
4, Level the range front to back and side to side with
the two front leg levelers and the rear levelers.
5. Slide range into place making sure rear legs are
trapped by ends of brackets. Range may need to
be shifted slightly to one side as it is being pushed
back to allow rear legs to align with brackets.
Remove lower panel or storage drawer to inspect
brackets or grasp the top rear edge of the range
and carefully attempt to tilt it forward to make sure
range is properly anchored.
L
3
Ol
Install Hold
/8
| fe
Bracket
3/8"
eo
Back Edge of Range
a
a
a
a)
f e
Sor Rear Wall
pier: Screws
a > Per Bracket
Range Side
—
Panel Location
Install Hold
Down Bracket
Figure 10
For mobile homes, the range must be anchored to the
floor as illustrated in Figure 11.
1. Remove false panel or storage drawer to gain
access to the anchoring holes.
2. A 1/4" diameter hole is provided in the center of
each base rail for anchoring to floor.
Hole For Anchoring
Range to Floor;
Hole Located Approx.
Midpoint of Base Rail.
Figure 11
or drawer of this range can result in serious injuries and
also cause damage to the range.
Publicidad
