SUHNER ABRASIVE SMH 60-HTD Documentación Técnica página 13

2.1.3 d /c
etAching onnecting the collet chuck
Remove tool or clamping pin (see 2.1.2).
Completely unscrew the collet chuck and remove it. Clean
the collet chuck and the clamping cone before they are
reassembled. Reassemble by following these instructions
in reverse, ensure that you tighten the collet chuck without
using excessive force. Insert the tool or clamping pin and
tighten it using the collet chuck key.
Never tighten chuck collets without a tool or
clamping pin.
2.2 r
Ating dAtA
Power Input
Max. torque
Max. speed
EMB collet chuck
Noise level at 50'000 min -1
Vibration EN 60745
Insulation class
Weight
Dimensions Diameter of 30 mm x length180mm
2.3 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
aNDlINg
3.1 w
orking instructions
To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure. Exces-
sive pressure lessens the working capability of the hand
tool, as well as the life of the grinding tool.
3.2 s on/off
witching
Hold the hand tool firmly. Switch on the control unit.
Perform a test run where the tool runs without load
for at least thirty seconds. Do not use the grinding
tool if it is vibrating. When it is in operation, the
hand tool must always be held in your hand. Switch OFF
the control unit when work has been finished. The tool will
continue to run for a while after the hand tool has been
max. 280W
8.9Nm
1
60'000 min-
2.35mm / 3mm / 6mm / 1/4"
59.8dB(A)
2 2
<2.5m/s , K=1.3m/s
IP54
0.475kg
/o
PERaTIoN
switched OFF. Put the hand tool down safely, so that no
hazards can occur.
4. S
ERvIcE
4.1 p
reVentiVe mAintenAnce
Always keep the hand tool clean and in a dry
place. Worn collet chucks must be replaced.
4.2 s
pAre pArts
See page 2-3.
4.3 r
epAir
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.4 w
ArrAnty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages. Complaints can only
be honored if the hand tool is returned in the undisas-
sembled condition.
4.5 s
torAge
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C
4.6 d / e
isposAl nVironmentAl compAtiBility
This hand tool consists of materials which can be dis-
posed of in a recycling process. Before disposal, render
the hand tool unusable.
Do not throw the hand tool into the garbage collec-
tion.
According to national regulations this hand tool
must be disposed of in an environmentally-compatible
recycling process.
/m
aINTENaNcE
13