Bosch Nexxt 500 Serie Instrucciones De Instalación página 5

Improper connection ofthe
equipment grounding c onductor
canresult i na riskofelectric s hock.
Check witha qualified e lectrician or
service person ifyouareindoubtas
towhether thedryerisproperly
grounded.
DONOT modify theplugprovided
withtheappliance - ifitwillnotfit
theoutlet h ave a proper o utlet
installed b yaqualified e lectrician or
exchange thecordwithan
appropriate onerated forthedryer.
KEEP THESE
INSTRUCTIONS FOR
FUTURE REFERENCE.
In case of change of ownership,
manual should be conveyed with the
dryer.
SAVE THESE
INSTRUCTIONS!
INSTALLATION INSTRUCTIONS
Introduction
Read these installation instructions
completely and carefully. They will save
you time and effort and help to ensure
optimum dryer performance. Be sure to
observe all listed warnings and
cautions.
These installation instructions are
intended for use by qualified installers.
In addition to these instructions the
dryer must be installed:
- In the U.S.A., in accordance with
the National Electric Code,
ANSI/NFPA70 -latest
edition/State and Municipal codes
and/or local codes.
- In Canada, in accordance with the
Canadian Electric Code C22.1 -
latest edition/Provincial and
Municipal codes and/or local
codes.
The gas installation must conform with
local codes, or in absence of local
codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 or the
CAN/CSA-B149.1, Installation Codes.
Note:
This gas dryer has been UL and C-UL
listed for safe operation up to a height
of 7,700 ft. without any modifications to
components for natural or propane
gas.
Information concerning
waste disposal
Disposal of the packaging
Keep children away from shipping
carton and packaging components.
Danger of suffocation from plastic
foil and folding cartons.
All packaging materials are
environmentally friendly and can be
reused. Please dispose of packaging in
an environmentally friendly manner.
Please ask your dealer or inquire at
your local authority about current
means of disposal.
Disposal of the appliance
If appliance is no longer usable, pull
out main plug, cut off power cord
and discard with main plug.
To prevent children from locking
themselves in the appliance, remove
the door.
Old appliances are not worthless
rubbish! Valuable raw materials can be
reclaimed from environmentally friendly
recycling.
Please ask your dealer or inquire at
your local authority about current
means of disposal.
Before installing the dryer
Unpacking the appliance
The dryer is very heavy. Do not lift it
by yourself. Do not lift the appliance
by projecting components (e.g.
door) - due to risk of breakage.
Remove the appliance packaging
carefully to prevent damage to the
surfaces.
Check the dryer for transportation
damage. Do not connect a dryer which
is visibly damaged. If in doubt, contact
your dealer.
Supplied components
After removing the packaging,
immediately remove any objects
from the drum.
The dryer is delivered as a complete
unit. The operating instructions and
supplied accessories can be found in
the drum.
Installation location
Do not install the dryer:
- outdoors,
- in an environment with dripping
water,
- near flammable materials,
- in rooms which are at risk of frost,
- in rooms which may contain gas
or other fuels,
- in cupboards with Iockable doors
or in alcoves.
- with other fuel-burning appliance
in the same closet.
The installation room must be well
ventilated, otherwise the dryer will
operate below optimum performance.
Do not operate the dryer at
temperatures above 104 °F (40 °C) and
below 41 °F (5 °C). Low temperatures
affect the automatic program sequence
and may prolong the drying times.
The installation surface for the dryer
must be clean, level and firm. Do not
install the appliance on carpets!
Compensate for uneven floors with the
height-adjustable feet.