Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting
the water inlet hoses
•
Pliers (that open to 19/16" [39.5 mm])
•
Flashlight (optional)
Tools needed
for installation
•
Open end wrenches 17 mm and 13 mm
•
Level
•
Wood block
•
Ruler or measuring tape
Parts supplied
Pedestal
You have the option of purchasing a pedestal for this washer. You
may select a 10" (25.4 cm) pedestal. Remember that the pedestal
will add to the total height of the unit.
A
Optional pedestal
A. Drain hose form
B. Inlet hose (2)
C. Inlet hose washer (4)
C
0
D. Transportbolt hole
plug (4)
E. Beaded strap
Alternate
Parts
Parts listed are available from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME
® (1-800-469-4663).
To order, call your local Sears store. For further information,
please call 1-800-4-MY-HOME
®(1-800-469-4663).
Pedestal
Approximate
height
Color
Model
Height
with washer
Number
10" (25.4 cm)
46" (116.8 cm)
White
46822
Stack Kit
Are you planning to stack your Kenmore washer and dryer? To do
so, find the stack kit (Part Number 8572546) in the drum of the
matching Kenmore dryer. Follow instructions
included with the
kit. See "Location
Requirements."
Selecting the proper location for your washer improves
Laundry tub or
standpipe taller
than 96" (2.4 m)
Sump pump system (if not already
available)
Overhead sewer
Standard 20 gal. (76 L), 30" (76.2 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain
Siphon break, Part Number 285834;
additional drain hose, Part
Number 8318155; and connector
kit,
Part Number 285863
Drain hose too
4 ft (1.2 m) drain hose extension kit, Part
short
Number 285863
Water faucets
2 longer water fill hoses:
beyond reach of
6 ft (1.8 m) Part Number 76314
fill hoses
10 ft (3.0 m) Part Number 350008
basement, laundry room, closet, or recessed area. See "Drain
System."
Companion appliance location requirements should also be
considered.
Proper installation is your responsibility.
You will need
•
A water heater set to deliver 120°F (49°C) water to the
washer.
•
A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
•
Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6
kPa).
•
A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 Ibs (180 kg).
Do not operate your washer in temperatures
below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
iiii .......
Publicidad
