ASSEMBLY INSTRUCTIONS
8. Twist end of house lead wire (black) and end of
fixture lead wire together. Twist wire connector
(AA) onto ends of wires. Completely tighten
wire connector (AA). Twist end of house neutral
wire (white) and end of fixture neutral wire
together. Twist wire connector (AA) onto ends of
wires. Completely tighten wire connector (AA).
Reference chart to the right for correct wire
connections.
9. Wrap electrical tape (not included) around wire
connectors (AA) and wires. Ensure wires are
securely fastened into wire connectors.
10. Carefully push all wires and wire connectors (AA)
into junction box.
Installing the Fixture to the Wall
11. Place backplate of fixture (B) over mounting
bracket (A). Pass holes in backplate of fixture
over ends of mounting screws (F).
12. Screw one threaded cap (G) onto end of each
mounting screw (F). Tighten threaded caps (G) to
secure fixture to wall. DO NOT over tighten.
Installing the Shades and Bulbs
13. Carefully lower hole in bottom of glass shade (C)
over socket. Thread socket ring (D) onto socket.
DO NOT over tighten.
14. Screw recommended bulb (E) (E26 Edison bulb
type, not included) into socket. Verify correct
bulb wattage marked on socket of fixture.
WARNING: DO NOT exceed maximum bulb
wattage.
steps 8-10
Connect Black Lead
Supply (House) Wire to:
Black Wire or,
*Parallel Cord
(Round and Smooth) or,
No printed words on
wire insulation or,
Insulated Wire
(other than green)
with Copper Conductor.
*When parallel wire (SPT 1 & SPT 2) is used:
The lead wire is round in shape or smooth.
The neutral wire is square in shape or ridged.
FIXTURE LEAD WIRE
FIXTURE GROUND
WIRE
FIXTURE NEUTRAL
WIRE
steps 11-14
A
6
Connect White Neutral
Supply (House) Wire to:
White Wire or,
*Parallel Cord
(Square and Ridged) or,
Printed words on
wire insulation or,
Insulated Wire
(other than green)
with Silver Conductor.
HOUSE LEAD WIRE
(BLACK)
HOUSE GROUND
WIRE (COPPER)
HOUSE NEUTRAL WIRE
E
D
C
F
B
G
(WHITE)