Publicidad
Idiomas disponibles
Idiomas disponibles
Insect Killer Use instructions
PRODUCT AND ACCESSORIES
1. Switch on/off
2. Fixing chain
3.4. Neon lights (20W)
5. Slide base plate
6. Remote control
INSTRUCTION FOR USE
Place the appliance following carefully the instructions mentioned above.
Plug the supply cord in the supply power.
Switch on the appliance by pressing the button on/off (1) or using the remote control (6).
To remotely control the mosquito killer, please use the included remote control.
ATTENTION: THE REMOTE CONTROL ONLY WORKS IF THE ON/OFF (I) BUTTON ON THE
MOSQUITO KILLER IS PLACED ON ON POSITION TO AVOID AN UNWANTED STARTING.
The Neon lights (3 and 4) will light and the insects naturally attracted by the UV light will fly to the
electric metallic grid and will be fulminated instantaneously.
The insects will fall into the slide base plate (5).
After use, switch off the appliance by pressing the button on/off (1) or using the remote control (6).
CLEANING AND CARE
Cleaning of the slide base plate and the grid
Before cleaning, switch off the appliance and unplug the supply cord.
Remove the slide base plate (5), empty and wash it using a detergent.
Replace the slide base plate.
Clean the metallic grid into the appliance with a flexible brush. Do not let insects on the grid.
Do not use metallic products to clean the appliance.
The plastic external parts can be cleaned with a soft cloth, water and natural detergent. Do not
immerge into water.
Make sure that every parts are completely dry before using again.
Replace UV neons Fig.2
To replace the UV neon, follow these steps:
1. Before starting any operation MAKE SURE TO UNPLUG THE DEVICE.
2. Take out the slide base plate.
3. Remove the screws from the bottom of the insect killer with a screwdriver.
4. Remove the two external protection grids.
5. Replace the tubes (as shown in the figure).
6. Reassemble the insect killer by repating these operations backwards
Attention: Make sure that the spare parts have the same features.
10
Publicidad
