Craftsman 917.387561 Manual Del Usuario página 14

• I,WARNING: To avoid serious injury,
before performing any service or adjust=
merits:
1. Release control bar and stop engine,
2, Make sure the blade and all moving
parts have completely stopped,
3, Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with plug,
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual,
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibility that objects will
be thrown out of the rear of the mower
into the operator's mowing position, If the
deflector becomes damaged, it should be
replaced,
DISCHARGE GUARD
The discharge guard, attached to the
discharge opening of your lawn mower, is
provided to prevent the possibility of injury
resulting from objects being thrown out of
the discharge opening into the operator
mowing position. If the discharge guard
becomes damaged, it should be replaced,
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1, Remove upper handle and all wire
tie(s) securing cable(s) to lower handle,
2, Remove hairpin cotters from lower
handle bracket mounting pin,
3, Squeeze lower handle in to remove it
from mounting pins,
4, Turn lower handle over to raise or
lower handle.
5, Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
6, Reassemble upper handle and all
parts removed from lower handle,
SQUEEZE
TO ADJUST
Lower handle
Handle
b racket
S
Mounting
Hairpin cotter
/ /I
\
\,
\.
Lower
handle
ROTATE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow, take your mower to a Sears or
other qualified service center for repair
and adjustment,
14