SNOWJOE 24V-X2-17LM Manual Del Operador página 11

Fig. 7
Grass collection bag
3. Release the ejector flap so that it rests on the grass bag.
(Fig. 8).
Fig. 8
Grass
collection
bag
Mulching Plug Assembly + Fitting
Your mower is equipped with a mulching plug to allow the
blade to cut and recut the grass for finer clippings.
NOTE: When using the mulching plug, do not assemble the
grass collection bag.
NOTE: When the grass collection bag is not attached, the
mulching plug must be inserted in the rear discharge opening.
1. Lift up the ejector flap.
2. Insert the mulching plug fully into the rear discharge
opening and make sure it's seated securely (Fig. 9).
Fig. 9
Ejector
flap
3. Release the ejector flap.
Operation
This lawn mower is intended for private residential use to cut
grass in small lawns and gardens. This lawn mower is not
intended to cut grass in public parks, playing fields, farms or
forests. Do not use this lawn mower for any application other
than that for which it is intended.
Adjusting the Cutting Height
Ejector flap
This cordless lawn mower is equipped with a 6-position height
adjustment lever to tailor grass cutting heights from 1 in. to
3 in. (25 mm to 75 mm). To change the cutting height of the
grass, follow the instructions below.
m
WARNING!
the batteries and the safety key from the lawn mower and wait
until the rotating blade has come to a complete standstill.
ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
1. Power off the lawn mower and remove the batteries and
the safety key.
2. Push the cutting height adjustment lever to the outside of
the original slot (Fig. 10).
Fig. 10
11
Mulching plug
Before making these adjustments, remove
Height
adjustment lever
Ejector flap
Rear
discharge
opening