Craftsman 917.28852 Manual De Instrucciones página 18

BATTERY
Your tractor has a batter_j charging system
which is sufficient for normal use, However,
periodic charging of the battery with .an au-
tomotive charger will extend its life.
Keep battery and terminals clean.
Keep battery bolts tight,
• Keep small vent holes open.
• Recharge at 6-10 amperes for 1 hour.
NOTE: The original equipment battery on
your tractor is maintenance free, Do not
attempt to open or remove caps or covers.
Adding or checking level of electrolyte is
not necessary.
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and termi-
nals can cause the battery to "leak" power.
1. Disconnect BLACK battery cable first
then RED battery cable and remove
battery from tractor,
2. Rinse the battery with plain water and dry,
3. Clean terminals and battery cable ends
with wire brush until bright.
4. Coat terminals with grease or petroleum
i_lly.
5. Reinstafi battery (See "REPLACING
BATTERY" in the SERVICE AND AD-
JUSTMENTS section of this manual).
V-BELTS
Check V-belts for deterioration and wear after
t00 hours of operation and replace if neces-
sary. The belts are not adjustable. Replace
belts if they begin to slip from wear.
TRANSAXLE COOLING
The transmission fan and cooling fins should
be kept dean to ensure proper cooling_
Do not attempt to clean fan or transmission
while engine is running or while the trans-
mission is hot, To prevent possible damage
to seals, do not use high pressure water or
steam to clean transaxle.
• Inspect cooling fan to Ensure fan blades
are intactand clean.
ENGINE
LUBRICATION
Only use high quality detergent oil rated with
APt service classification SG-SL. Selectthe
oil's SAE viscosity grade according to your
expected operating temperature.
$AE V_SCOS£_Y GRAD:ES
C -_ -s0 -to _ 1o 2g _o 40
_"EMp ERATU'RE RANGE ANTIC _'PATED_"OR E N_T OIL C_*NG_
NOTE: Although multi-viscosity oils(5W30,
10W30 etc.) improve starting in cold weather,
they will result in increased oil consumption
when used above 32°F/0°C. Check your
engine oil level more frequentlyto avoid pos-
sible engine damage from running low on oil.
Change the oil after every 50 hours of opera-
tion or at least once a year ifthe tractor is
not used for 50 hours in one year.
Check the crankcase oil level before starting
the engine and after each eight (8) hours
of operation. Tighten oil fill cap/dipstick
securely each time you check the oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change. Ail oil must meet AP1
service classification SG-SL,
• Be sure tractor is on level surface.
• Oil will drain more freely when warm.
• Catch oil in a suitable container,
1. Remove oil fill cap/dipstick. Be careful
not to allow dirt to enter the engine when
changing oil.
2. Slide oil drain extension fromthe docking
position on the engine blower housing
and extend outward from engine.
-T-lnspectcooling fins fordirt; grass clippings ........ D°cki_g .......................... Oil=Drain ...............
and other materials, Toprevent damageto .....
seals, do not use compressed air or high
pressure sprayer to clean cooling fins.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and
fluid maintenance is not required for the life
ofthe transaxle. Should the transaxle ever
leak or require servicing, contact your near-
est Sears or other qualified service center.
nsion
3. To open, twist cap counter-clockwise
4. After oil is drained completely, replace
cap and twist clockwise until it stops.
5. Re-attach oil drain extension to engine
blower housing.
18