Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
General
Use Instructions
Ak WARNING:
Be sure to read, understand,
and apply all the information in the important Safety
instructions
section at the beginning of this operator's
manual.
Do not operate in
areas with flammable gases, vapors, or explosive dusts in the air. Flammable gases
or vapors include but are not limited to: lighter fluid, solvent type cleaners, oil-
base paints, gasoline, alcohol, or aerosol sprays. Explosive dusts include but are
not limited to: coal, magnesium, grain, or gun powder. To reduce the risk of health
hazards from vapors or dust, do not use around toxic materials.
1. Verify that the 3-speed on/off switch is set to "0" (OFF) and the cord is unplugged.
2.
Place the air mover in the desired position
on a stable surface.
Ensure there is
at least a foot of clearance on each side of the air mover. Avoid placing the air
mover where loose fabric, sheets, or other objects can get pulled onto the intake
grills.
3. Direct air mover at the designated
target area, using one of the operational
positions
listed on page 7.
4. Plug in the air mover to a grounded,
GFCl-protected
outlet.
See page 4 for
grounding
instructions.
DO NOT USE WiTH AN EXTENSION CORD
5. Turn on the air mover by rotating the 3-Speed On/Off Switch clockwise
to the
desired power level (I, II, or lil).
6.
The air mover is equipped
with an overload protection
feature,
if the air mover is
overloaded,
it will shut off and will need to be reset before it can be used again. If
this occurs, set the 3=speed on/off switch to "0" (OFF) and press the reset button.
Check that there are no obstructions
preventing
airflow into the intake grills
before turning on the air mover again.
7. When finished with use, turn the 3-speed on/off switch counter-clockwise
to the
"0" (OFF) position and unplug the power cord from the outlet.
See page 8 for
storage instructions.
Publicidad
