Publicidad
Idiomas disponibles
Idiomas disponibles
WAC
8-24
USER
MAN
FINAL
3/2/05
12:13
PH
Page
15 0
OPERATING iNSTRUCTiONS
MODE
The mode knob controls fan speeds and cooling
speeds. To set desired cooling temperature,
simply
rotate the mode knob dial to the appropriate
setting.
THERMOSTAT
The thermostat
automatically
controls the cooling
cycle (compressor)
of the air conditioner
to maintain
room temperature.
However, the fan motor will
continue
to operate after the compressor
(cooling
cycle) is completed.
LOW FAN will circulate the air at a minimum
speed
without cooling.
MED FAN will circulate the air at a middle speed
without cooling.
HIGH FAN will circulate the air at a maximum
speed
without cooling.
LOW COOL provides cooling,
automatically
with
minimum
air circulation.
Recommended
for night-
time use.
MED COOL provides cooling, automatically
with
middle air circulation.
Recommended
for night-
time use.
HIGH COOL provides cooling, automatically
with
quick cooling or for extremely
hot days. Once room
is cooled, reduce setting to LOW COOL.
OFF will completely
shut-off the unit.
NOTE: After setting the mode, allow 3
minutes before switching to another mode.
V_I
[e_:_lJlill:o]_l
V_
Fresh Air Ventilation
is usually kept in the closed
position.
Use only when clearing smoke and/or
odors from the room. Pull to open.
Thermostat
Mode knob
knob
Fig. 15
When using FAN control, turn slowly allowing
unit to adjust.
When using THERMOSTAT, be sure to allow
three minutes before changing temperature.
Adjusting too quickly may cause an overload
resulting in a blown fuse.
Fresh Air
Vent Lever
Fig. 16
Publicidad
