Publicidad
Instalation
1. Remove the power supply from its
packaging.
2. Use the provided screws to install the power
supply into your computer case. NOTE: It is
recommended to install the power supply with
the fan facing down.
However, if your case places the power supply
at the bottom of the case and there are no
ventilation holes there, it may be best to install
the power supply with the fan facing up for
greater efficiency and reliability.
3. Connect the 24-pin ATX cable to the
motherboard.
NOTE: This power supply allows you to detach
the four right-most pins to make this
connector into a 20-pin connector. Under NO
circumstances should you plug the extra
four-pin connector into your mothetboard´s
4-pin ATX 12v or "P4" connector. Serious
damage may occur.
4. Connect the 8-pin EPS 12v cable(s) to the
motherboard.
One of the EPS12V connectors can be split to
form a 4-pin ATX 12v connector if your board
lacks an EPS 12v connector.
Publicidad
