Sears Kenmore 106.7200 Serie Manual De Uso Y Cuidado página 14

Press Humidity Control again to turn OFF and save energy
when the environment is less humid.
Press If Moisture
Appears
Temp Alarm (on some models)
The Temp Alarm feature provides temperature information in
the event of a power outage.
Power outage: During a power outage, if the temperatures in the
refrigerator and freezer compartments exceed normal
operating temperatures, the highest temperature reached will
be displayed.
• Press the Temp Alarm touch pad until the indicator light is lit,
to turn on this feature. Press and hold Temp Alarm for
3 seconds until the indicator light goes off, to turn off this
feature.
Temperature alarm: An alarm will sound repeatedly if the
freezer or refrigerator compartment temperatures exceed
normal operating temperatures for an hour or more.
The temperature displays will alternately show the current
temperatures and the highest temperatures the compartments
reached.
Press the Temp Alarm touch pad once to stop the audible
alarm and alternating temperature displays. The Temp
Alarm light will continue to flash until the refrigerator returns
to the set temperature.
@
©
Filter Reset (on some models)
The Filter Reset control allows you to restart the water filter
status tracking feature each time you replace your water filter.
See "Water Filtration System."
• Press and hold the Filter Reset touch pad for 3 seconds, until
the Replace light turns off.
Order Replace
Press & Hold
User Preferences
The control center allows you to set user preferences, if desired.
Temperature Display (F_C)
This preference allows you to change the temperature display.
F - Temperature in degrees Fahrenheit
C - Temperature in degrees Celsius
Alarm (AL)
This preference allows you to turn off the sound of all alarms.
ON - You will hear the alarm sound.
OFF - You will not hear the alarm sound.
Sabbath Mode (SAB)
ON - All control center lights and alarm tones will be disabled.
OFF - All control center lights and alarm tones will be enabled.
NOTE: Press the Door Ajar touch pad for 3 seconds to restore
all lights.
To Access the User Preferences Menu:
1. Press and hold the Door Ajar touch pad for 3 seconds. The
preference name will appear in the Freezer display and the
preference status (F or C) or (ON or OFF) will appear in the
Refrigerator display.
2. Use the Freezer Up Arrow or Down Arrow touch pads to
scroll through the preference names. When the desired
preference name is displayed, press the Refrigerator Up
Arrow or Down Arrow touch pads to change the preference
status.
3. Set your preferences by pressing and holding the Door Ajar
touch pad for 3 seconds.
IMPORTANT:
After connecting the refrigerator to a water source or
replacing the water filter, flush the water system. Use a
sturdy container to depress and hold the dispenser lever for
5 seconds, then release it for 5 seconds. Repeat until water
begins to flow. Once water begins to flow, continue
depressing and releasing the dispenser lever (5 seconds on,
5 seconds off) until a total of 4 gal. (15 L) has been
dispensed. This will flush air from the filter and water
dispensing system, and prepare the water filter for use.
Additional flushing may be required in some households. As
air is cleared from the system, water may spurt out of the
dispenser.
• Allow 24 hours for the refrigerator to cool down and chill
water. Dispense enough water every week to maintain a
fresh supply.
Dispensing Water
1. Hold a container under the dispenser while pressing the
button.
2. Release the button to stop dispensing.
14