Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Opecat[on
RECEPTACLES
l
CAUTION
. NEVER attempt to power a device requiring more amperage
than generator
or receptacle can supply.
. DO NOT overload the generator: See "Don't Overload
_enerator",
120/240
Volt AC, 30 Amp,
Lod<ing
Use a NEMA LH 4-30 piug with this receptacie.
Connect
a
4-wire
cord set rated for 250VoHtAC
ioads at 30 Amps (or
greater)
(Figure 5).You can use the same 4-wire
cord if you
_ian to run a i20Voit
ioad.
4oWire
Cord Set
J
NEMA
LI4-30
(Neutral)
Y (Hot)
|
X (Hot)
7 Ground (Green)
This receptacle powers
i20/240VoitAC,
60 Hz, single
phase loads requiring up to 6,000 watts of power (6.0 I<W)
at 30 Amps for H20VoHtsor 240Volts.The
outHet is
protected
by a push-to-reset
circuit breaker.
120 Volt AC, 20 Amp,
Duplex
Use each receptacle
to operate
i20VoitAC,
singie-phase,
60 Hz electrical
loads requiring
up to 2,400 watts
(2.4 I<W)
at 20 Amps of current.
Use cord sets that are rated
for
125 Volt AC loads at 20 Amps (or greater).
G E N E RATO R ADAPTE
R
CORD
SET
The generator is equipped with a 25' generator adapter cord
set designed for a 240Volt, 30Amp grounded neutral circuit
(Figure 7).The generator adapter cord set provides a
convenient supply of emergency power into your dwelling so
that your generator can be operated safely outside.
Each duplex receptacle (Figure 6) is protected
against
overioad by a push-to-reset
circuit breaker.
The maximum load on each oudet is 20 Amps.The
maximum total load on both yellow wire oudets or blacl<
wire
outlets
is 30
Amps.
NOTE:
Follow all safety precautions
when connecting any
extension
cord or device to the generator.
Publicidad
