Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING: ALWAYS disconnect from the power supply before carrying out any mainte-
nance/cleaning.
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time.
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised WOLFPACK service centre. This advice also applies to exten-
sion cords used with this tool.
Lubrication
• Lubricate all moving parts with a suitable lubricant spray, at regular intervals.
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves when
cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the device's service life.
• Clean the body of your machine with a soft brush, or dry cloth.
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild deter-
gent on a damp cloth is recommended.
• Water must never come into contact with the tool.
• Ensure the tool is thoroughly dry before using it.
• If available, use clean, dry, compressed air to blow through the ventilation holes (where
applicable).
Brushes
• Over time the carbon brushes inside the motor may become worn.
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking.
• If you suspect that the brushes may be worn, have them replaced at an authorised
WOLFPACK service centre.
Storage
• Store this tool and its accessories after use in its case, in a dry, secure place out of the
reach of children.
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No load speed
Oscillating angle
Ingress protection IP20 Length of power cord
Weight
230-240 V
50Hz
300W
11000~23000 min-1
3.2°
2m
1.34kg (without accessories)
38
Publicidad
