Bosch PAM0320 Instrucciones De Uso página 26

Warning!
Remember that when the appliance is
turned off and turned back on, it is
necessary to wait for approximately 3
minutes before the compressor starts up
again. This period of time is required in
order to ensure correct appliance
operation.
Ways of releasing air outdoors
Fitting the air expulsion tube and
accessories onto the appliance
Fit the air expulsion tube onto the fixture with
the "push" tab and thread it anti-clockwise,
Fig. 10.
Fig. 10
If easier, the housing can also be removed
from the appliance by pressing the "Push" tab
and sliding it out, Fig. 11A.
Fig. 11A
Once out, thread the expulsion tube as shown
on Fig. 11B, making sure that it is properly
secured.
Fig. 11B
Instructions for Use
Housing for the air
expulsion assembly
Then fit the assembly onto the appliance by
slotting it into position Fig. 12.
Fig. 12
Securing the diffusion duct onto the air
expulsion tube
Fit the diffusion duct onto the free end of
the tube pushing both parts gently until the
duct clicks into place. Make sure that the
clips are closed. Otherwise, the duct may
fall off. Fig 13.
Temporary installation
Open the window slightly and position the
diffusion duct between the jamb and the
glaze frame.
Close the window as far as possible and
secure it with the suction pad supplied,
Fig. 14.
26
¡clac!
Fig. 13
Fig. 14