Publicidad
Idiomas disponibles
Idiomas disponibles
If the tractor does not come to a complete stop when
the brake pedal is completely depressed, or if the
tractor's rear wheels can roll with the parking brake
applied, the brake is in need of adjustment. The brake
disc can be found on the right side of the transmission
in the rear of the tractor. Adjust if necessary as follows:
•
Looking at the transmission from the right side of
the tractor, locate the compression spring and
brake disc. See Figure 11.
HexNut
___
Set Gap
at.011"
Compression
Spring
NOTE:
View shown from beneath tractor,
Transmission
Figure 11
•
Loosen, but do NOT remove, the hex nut found on
the right side of the brake assembly. See Figure 11.
•
Using a feeler gauge, set the gap between the
brake disc and the brake puck at.011 ".
•
Re-tighten the hex nut loosened earlier.
SeatAdjustment
To adjust the position of the seat, loosen the two hex
screws on the bottom of the seat. Slide the seat forward
or backward as desired. Retighten the two screws. See
Figure 12.
Hex Screws
Figure 12
Steering Adjustment
If the tractor turns tighter in one direction than the other,
or if the ball joints are being replaced due to damage or
wear, the steering drag links may need to be adjusted.
Adjust the drag links so that equal lengths are threaded
into the ball joint on the left side and the ball joint on the
right side:
•
Loosen the jam nut found on the drag link at the
rear of the ball joint. See Figure 13.
Hex Nut
Pivot Bar
Dra_j Link
Jam Nut
Ball Joint
Figure 13
•
Remove the hex nut on the top of ball joint. See
Figu re 13.
•
Thread the ball joint toward the jam nut to shorten
the drag link. Thread the ball joint away from the
jam nut to lengthen the drag link.
•
Replace hex nut and retighten the jam nut after
proper adjustment is achieved.
NOTE:
Threading the ball joints too far onto the drag
links will cause the front tires to "toe-in" too far. Proper
toe-in is between 1/16" and 5/16".
Front tire toe-in can be measured as follows:
•
Place the steering wheel in position for straight
ahead travel.
•
In front of the axle, measure the distance
horizontally from the inside of the left rim to the
inside of the right rim. Note the distance.
•
Behind the axle, measure the distance horizontally
from the inside of the left rim to the inside of the
right rim. Note the distance.
•
The measurement taken in front of the axle should
be between 1/16" and 5/16" less than the
measurement taken behind the axle. Adjust if
necessary.
17
Publicidad
