Brita HUB Manual Del Usuario página 8

How to Install and Flush Water Filter (and Replace Filters)
1.
Unplug. To remove Filter Access
Panel on left side of Brita Hub™:
Place fingers into notch at top-left
side of Hub, then pull panel out
and lift up.
5.
Use Water Reservoir Handle and
lift straight up to remove. Add
only cold water up to MAX Fill
line.
8
2.
Place hand on top of Brita Hub™ to steady while inserting new Water Filter.
To insert Water Filter: Using other hand, hold Water Filter with Brita logo
facing you, then insert and push top end of Filter into Water Filter Holder
(see page 5) until you hear 2 clicks to ensure Filter is fully inserted.
3.
OR To remove used Water Filter, hold sides of Water Filter with one hand
while pressing Eject Button, pull straight down and dispose or recycle with
TerraCycle. Visit brita.com/recycling to learn more.
6.
Align and lower Water Reservoir
onto Water Reservoir Base. Place
Lid on Water Reservoir.
OR
7.
Plug into outlet. Press and hold ( ) Manual Dispense Button until Reservoir
is empty. Dispose of water, or use to water plants. Refill Reservoir to MAX
Fill line and repeat process. New Filter must be flushed with an entire Water
Reservoir of water twice before it is ready to use.
4.
Reinstall panel on left side.
Remove Lid on Water Reservoir.