Vlectro OP 011954 Manual De Instrucciones página 8

EN
Please read the instruction carefully before installation and use.
Specifications
Receiver: 4 x AAA ba eries (not
included)
Ba ery (transmi er): 12V 23A
(included)
Range: Up to 150m
Sound level: 0 - 100dB, 4 levels (mute
included)
Transmission frequency:
433Mhz±0.5Mhz
Accessories
Transmi er
Receiver
12V 23A ba ery
Mounting screws
Double-sided tape
Installation
You can install the transmi er with either double-sided tape or screws:
1. To mount with screws, open the transmi er with a screwdriver. Penetrate the two holes
at the back cover with two screws. Then fix the screws on the wall at a suitable height.
Mounting on UPVC or metal doorframe surfaces will reduce the transmi ing range.
To install using screws you will require a drill and cross-headed screwdriver.
IMPORTANT: Prior to drilling any holes into the wall, ensure that there are no cables or
pipes present that may be inadvertently damaged.
2. Use the double-sided adhesive tape to fix the transmi er on the wall.
Receiver
Insert 4 x AAA ba eries into the ba ery compartment, please note the correct ba ery
polarity.
Doorbell
Press the bu on on the transmi er once to send a wireless signal to the receiver which
will then chime. Holding the bu on will not repeat the sound.
Melody
Press the music bu on to change the doorbell melody, Press and hold the music bu on for
3 seconds to reset the melody.
Important
1. The receiver is only for use indoors.
2. Don't a ach the transmi er to a metal surface or a UPVC doorframe, as this will lessen
its operation range.
3. Avoid exposing the receiver to water or submerging any of the units in water.
4. Do not install either device near a fireplace or subject it to high temperatures.
5. If you're not using the doorbell for a long time, remove the ba ery from both the
transmi er and the receiver
6. Dispose of the old ba ery in accordance with the applicable laws.
6