Bosch Nexxt 800 Serie Operacion, Cuidado E Instrucciones Para La Instalacion página 19

9. Take the dryer rack out of the
drum.
i
10. Re insert the lint filter.
Drying shoes on the dryer rack:
1. Prepare shoes.
Clean shoes to prevent the drum
from becoming soiled.
If preparing sports shoes, extend
the tongue.
Loosen or remove shoe-laces.
Remove insoles and heel pads.
2. Place shoes on the rack.
Directly on the dryer rack
or
Roll up a towel and place the
heels of the shoes on the towel,
This will ensure a more uniform
drying result,
3. Close the door.
Permanent p_'ess
ECQSENS0R Off
l v0ry_ry '
I
ReguladCoUon
ECOSENSOR
tegulardry Mix
Air fluff/Noheat
Medium 1'line_
4. Program selector to "Time
dry/High",
start in Readyin
5. Select the required drying time
with the "Select" button.
6. If there is still residual moisture at
the end of the drying time, repeat
the program.
7. At the end of the drying time take
the shoes out of the dryer and
leave to air for approx. 30 min,
8. Remove the lint filter.
9. Take the dryer rack out of the
drum.
10. Re-insert the lint filter.
Cleaning and care
Cleaning the dryer
TO AVOID
RISK OF EXPLOSION!
Never use solvents or highly
flammable liquids for cleaning.
Incorrect cleaning may damage
the dryer. Do not spray with a
water jet. Do not use scouring
agents or all purpose cleaners.
Do not use steam cleaners.
Wipe the housing and fascia with a soft
cloth and soapy water only.
Wipe the drum, door seal and inside of
the door with a damp cloth only.
Cleaning the lint filter
A dirty filter extends the drying time and
increases energy consumption.
The filter should be cleaned before and
after each drying process.
If a warning signal and an E01 warning
message are emitted during a drying
program, clean the filter immediately
and check the exhaust duct.
[_The program interrupts
automatically.
1. Switch off the dryer. Program
selector to "Off".
The inside of the door heats up
during the drying process.
2. Open the door.
I
3. Remove the lint filter.
19