Cleaning And Maintenance - Stanley ST-02-230-E Instrucciones De Uso

NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING, OR WHILE CONNECTED
TO A POWER SOURCE.
Special Safety Regulations (cont.)
- It is recommended that a separate circuit serving only
this appliance be provided. Keep the power cable far
enough from the hot air outlet.
- If the supply cable is damaged, it must be replaced by
the manufacturer or service agent or a similarly qualified
person in order to avoid a hazard. - You must not con-
nect other appliances to the same electrical outlet as
the fan heater.
- Do not dispose of electrical appliances as unsorted
municipal waste; use separate collection facilities.
Contact your local government for information regarding
the collection systems available. If electrical appliances
are disposed of in landfills or dumps, hazardous sub-
stances can leak into the groundwater and get into the
food chain, damaging your health and well-being. When
replacing old appliances with new ones, the retailer is
legally obligated to take back your old appliance for
disposals free of charge.
- If the fan heater is to be permanently installed, the fol-
lowing instructions must be observed (see figure 2).
- The fan heater is not suitable for use outdoors in damp
weather, in bathrooms or in other wet or damp environ-
ments.
- Please note that the fan heater can become very hot
and should, therefore, be placed at a safe distance from
flammable objects such as furniture, curtains and similar
objects.
- Do not cover the fan heater.
Assembly
1. Slide upper handle brackets onto front handle and align
holes .
2. Slide rear handle into upper handle brackets and align
holes.
3. Slide side support into upper bracket and align holes.
4. Attach upper brackets to heater using 3 screws per side.
5. Place heater on one side.
6. Align lower inner bracket with holes in heater and side
support.
7. Attach align holes in Heater leg frame with lower inner
bracket.
8. Align lower outer bracket holes with lower inner bracket,
and attach using screws.
9. Place heater on opposite side, and repeat steps 6-8.
STANLEY and
EN
are trademarks of Stanley Black & Decker, Inc or its affiliates and are used under
license by Pinnacle Products International, Inc - www.pinnacleint.com
Operation
- Position the fan heater so that it stands upright on a firm
surface and at a safe distance from wet environments
and flammable objects.
- Connect the fan heater to the electrical power.
- Set the thermostat dial to the maximum temperature.
- The fan heater will switch on when the function selector
dial is set to one of the three power settings.
- Once the room reaches the desired temperature, turn
the thermostat dial back until heating element turns off.
The fan will still continue to run. The thermostat is now
set at your desired temperature, and the heater will con-
tinue to maintain a constant temperature.

Cleaning and Maintenance

- Before cleaning the appliance, disconnect it from the
outlet and let it cool down.
- The enclosure is easy to get dirty. Wipe it often with a
soft sponge. For very dirty parts, wipe with a sponge
dipped in < 50°C water and mild detergent, then dry the
heater enclosure with a clean cloth. Be careful not to let
the water enter the inside of the appliance
- In order to protect the enclosure, don't splash water onto
the heater, and never use a solvent like gasoline,
isoamyl acetate, toluene, etc. to clean the heater.
- Clean the coupler, dry and pack it in a plastic bag.
- When you store the heater, let it cool down first and,
keep it dry. Then cover it with a plastic bag, put it in the
packing box and store it in a dry, ventilated place.
Figure 2. Installing your Heater
Electric Fan Heater
7