ESX Signum Serie Manual De Instrucciones página 11

FIGURES
(P. 28-31)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) Power-/Protection-LED
(2) HIGH PASS controller
(3) Selector HP (Highpass) – FULL – LP/BP (Lowpass/Bandpass)
(4) LOW PASS controller
(5) LINE OUTPUT L/R
(6) LINE INPUT L/R
(7) BASS BOOST controller
(8) LEVEL INPUT controller
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) In-Line Fuse (not included in the scope of delivery)
(6) Turn on wire from the head unit or the electrical antenna
(7) Fuse(s)
2-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the head unit to drive two loudspeakers in
stereo, connect the following setup:
(1) To the head unit, line output left FRONT L/CH1
(2) To the head unit, line output right FRONT R/CH2
(3) Loudspeaker left FRONT L/CH1
(4) Loudspeaker right FRONT R/CH2
MONO OPERATION (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the head unit to drive a subwoofer, connect
the following setup:
(1) To the head unit, line output left FRONT L/CH1 or subwoofer output
(2) To the head unit, line output right FRONT R/CH2 or subwoofer output
(3) Subwoofer
11