Descargar Imprimir esta página

cecotec CONGA 7490 ULTIMATE X-TREME Manual De Instrucciones página 55

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 41
-
The robot vacuum cleaner will automatically turn on when placed on the charging base. 
-
The robot vacuum cleaner cannot be turned off during recharge.
Installing the mixed tank. Fig. 9
-
Open the water-tank silicone lid and carefully fill up the tank while avoiding spillages.
Make sure the lid is properly closed. Never immerse the tank in water or other liquids.
-
Install the mop on the mop bracket.
-
Install the mop bracket following the direction shown in figure 9.
-
To install the tank on the robot vacuum cleaner, follow the direction shown in figure 9 and
manually press the tab and push it into the correct position. You will hear a click when it is
properly fixed.
Recommendations
-
It is not suggested to use the scrubbing function for first-time use.
-
Do not use the mopping function if the robot vacuum cleaner is not being supervised. 
-
To remove the mop bracket, pull it outwards until the two hooks are released.
-
Uninstall the mop bracket when the robot vacuum cleaner is charging or when not in use. 
-
Add a few drops of cleaning agent to the water if necessary, as long as it is non-corrosive.
-
Using cleaning agents in excess might block water outlets.
-
In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First use
-
Once the robot vacuum cleaner and the charging base are installed, follow these steps
before the first cleaning.
-
First of all, fully charge the robot vacuum cleaner. It is suggested to allow the robot to
charge overnight. Once fully charged, it may carry out the first cleaning cycle and save
the first map. To do so, activate the Auto mode and select the Eco suction level. It is very
important to follow these instructions so that the robot vacuum cleaner recognises every
corner of your house and can carry out a complete mapping of it.
-
If your house is very large and the robot vacuum cleaner runs out of battery, it will return
to the charging base, save both complete and incomplete maps, and, once charged, it will
resume cleaning where it left off until the entire surface has been mapped. The robot
vacuum cleaner is constantly mapping, so it adapts in an individualised and personalised
way to the particularities of each house while constantly improving its map. 
CONGA 7490 ULTIMATE X-TREME
ENGLISH
55

Publicidad

loading

Este manual también es adecuado para:

08067