Publicidad
Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
•
On / Off
ON
Air pressure settings
1. With the pressure regulator you can set the desired pressure (0-6 bar). Pay attention to the nameplate of
the pneumatic tool to be connected.
2. The reservoir pressure can be checked on the gauge provided.
3. All compressors are equipped with a pressure regulator. By operating the knob with the tap open, turn
the regulator clockwise to increase the pressure and counterclockwise to decrease it, the air pressure
can be regulated to optimize the use of pneumatic tools.
4. The set value can be checked on the pressure gauge.
ATTENTION:
Check that the air consumption and maximum working pressure of the pneumatic tool to be used are
compatible with the pressure set on the pressure regulator and with the amount of air supplied by the
compressor.
Releasing overpressure
•
Switch off the compressor.
•
Use the overpressure with an idle pneumatic tool.
Condensate water drainage
Condensation water accumulates at the bottom of the boiler. You should periodically drain the tank to
protect it from corrosion and not restrict its capacity.
WARNING: Condensation water should only be drained when the boiler is NOT under pressure.
Safety valve
The safety valve is set to the maximum allowable pressure of the pressure vessel and protects the
compressor. As soon as the air in the vessel reaches or exceeds the maximum permissible operating
26
OFF
(adjusting pressure)
1. Open the drain plug at the bottom of the boiler
completely.
2. Tilt the compressor to one side so that the drain plug
is at the lowest point of the boiler and wait until the
condensate water has drained completely.
3. Close the drain plug again.
WARNING:
Always disconnect the plug and drain the tank
once you have completed your work.
Always wait at least 10 seconds after the
compressor shuts off before restarting the
compressor.
ATTENTION: The compressor must be turned off.
Publicidad
