Publicidad
Idiomas disponibles
Idiomas disponibles
2 Adjustment of minimum level of the flame
Control handle
Control handle
Tap
Tap
Sealing ring
Sealing ring
Adjustment screw
• Do not dismantle the tap shafe: in the event of a malfunction, change the whole tap.
• Before placing the burners back on the top place, make sure that the injector is not
blocked. carried out after gas conversion. (such as soap water or gas in the event
of a malfunction, change the whole tap.
• A full operational test and a test for possible leakages must be detector) Do not
dismantle the tap shafe:
• After completing conversion a qualified technician or installer has to mark "V" on
the right gas category to match with the setting in rating plate. Remove the previous
setting "V" mark.
1. Turn the taps down to minimum.
2. Remove the knob from the tap and place a small
bladed screwdriver in the centre of the tap shaft.
3. The correct adjustment is obtained when the
flame has a length of about 3 - 4 mm.
• For butane / propane gas, the adjusting screw
must Make sure that the flame does not go out by
quickly turning from maximum flow to minimum
flow. If it does then remove the control knob and
make further adjustments to the gas flow, testing it
again once the adjustment has been made.
4. Repeat this process for each one of the gas taps.
EN
43
Publicidad
