Page 4
2. General Information
2.1 Introduction
This manual contains information for the proper installation and operation of the Black & Decker Heat
Pump family. The instructions in this manual MUST be followed precisely.
2.2 Heat Pump Overview
The pool heat pump is a self-contained unit designed specifically for pool heating. Each component has been
selected with care to achieve a high-quality product in an effort to exceed all industry standards.
All pool heat pumps have an electronic board with service analyzer, a titanium heat exchanger tube warranteed for
10 years against corrosion, and a PVC plastic cabinet that eliminates all maintenance for life. All components are of
superior quality, which presents you with an effective heat pump.
Compared to other types of pool heaters, such as gas or oil-fired, the pool heat pump has a lower heating capacity
on a BTU/hr basis. Therefore, it needs to operate for a longer time to accomplish the desired results. Occasionally,
it may be necessary to run the heat pump for up to 24 hours per day. However, this should not be of concern to the
owner because the heater is designed to operate continuously. What's more, despite continuous operation, it will
still heat the pool far more economically than other types of heaters.
As with all pool heaters, you are advised to use a pool solar cover at night and when the pool is not in use. The
pool solar cover should be used if night temperatures are 15° F less than desired pool temperature. This will keep
evaporation, the greatest source of heat loss, to a minimum, thus greatly reducing the overall pool heating costs.
During warmer weather, the pool cover may not be required.
General Features
• Utilizes Warm Ambient Air for Increased Efficiency
• BT Certified for Long-term Reliability
• Exclusive Self-Diagnostics to Keep Performance High
• Easy Programming Controls for Optimal Use
• Quiet Motor and Consumer-Friendly Installation
• Voltage: 208 230V
• For Above Ground and Inground Pool Use
ENGLISH
Installation & Operation Manual