Publicidad
Idiomas disponibles
Idiomas disponibles
Device emissions values
Noise
The noise values have been determined in accordance
with EN 62841-1:2015.
Wear hearing protection.
Excessive noise can result in a loss of hearing.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
The stipulated values are emission values and so do
not necessarily represent safe work station values. Al-
though there is a correlation between emission levels
and exposure levels, it is not possible to reliably deter-
mine whether additional precautionary measures will
be required or not based on this. Factors that could
influence the emissions level present at any given time
at the work station include the duration of exposure,
the nature of the working area, other noise sources
etc. e.g. the number of machines and neighbouring
processes.
The permitted workstation values can also vary from
country to country. However, this information should
enable the operator to better evaluate the hazards and
risks.
Limit the noise level to a minimum!
• Only use devices which are free of defects.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
Suitable saw blades
All industry-standard saw blades with a minimum
length of 133 mm with and without a pin may be used.
7.
Before commissioning
7.1 Unpacking
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
34 | GB
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.
WARNING
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
80.4, dB
or suffocating!
3 dB
93.4 dB
7.2 General notes
• Prior to commissioning, all covers and safety devic-
3 dB
es must be mounted correctly.
• It must be possible for the saw blade to run freely.
• In case of previously machined wood, be aware of
any foreign objects, such as nails or screws, etc.
• Before pressing the on/off switch, make sure that the
saw blade is correctly fitted, and that moving parts
run smoothly.
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
• Only connect the machine to a correctly installed
protective contact socket, with fuse protection of at
least 10 A.
7.3 Install the scroll saw on the workbench (Fig.
5.1-5.2)
You require the following for assembly:
• M6 hexagonal bolt (4x)
• M6 hexagonal nut (4x)
• Washer Ø 6.4 mm (8x)
• Drilling template (Fig. 5.2)
The assembly material is not included in the scope of
delivery.
The length of the screws to be used vary depending on
the thickness of the tabletop.
WARNING
Risk of injury! Disconnect the mains plug on the scroll
saw before all assembly work.
1.
Mount the scroll saw on a solid wooden work-
bench. This way, a high noise level due to vibra-
tions can be avoided.
2.
Mark the drill holes using the dimensions (Fig. 5.2)
3.
Drill the 4 holes (diameter 6 mm) into the work-
bench.
www.scheppach.com
Publicidad
