Panasonic AG-MC200G Instrucciones De Funcionamiento página 2

Notice for the purchaser/user of the
apparatus
1. Applicable
environment
The apparatus is compliant with:
• standards EN55103-1 and EN550103-2 1996.11, and
• electromagnetic environments E1, E2, E3 and E4.
2. Pre-requisite
compliance with the above standards
<1> Peripheral equipment to be connected to the apparatus
and special connecting cables
• The purchaser/user is urged to use only equipment which
has been recommended by us as peripheral equipment to be
connected to the apparatus.
• The purchaser/user is urged to use only connecting cables
recommended by us or their equivalent as the optional
special cables.
<2> For the connecting cables, use shielded cables which
suit the intended purpose of the apparatus.
• Video signal connecting cables
Use double shielded coaxial cables, which are designed for
75-ohm type high-frequency applications, for SDI/SDTI
serial digital video signals.
Coaxial cables, which are designed for 75-ohm type high-
frequency applications, are recommended for analog video
signals.
• Audio signal connecting cables
Use cables designed for AES/EBU serial digital signal
transmission for AES/EBU serial digital audio signals.
Use shielded cables, which provide quality performance for
high-frequency transmission applications, for analog audio
signals.
• Control system connecting cables
Use shielded cables, which provide quality performance for
high-frequency transmission applications, as control system
connecting cables.
3. Performance level
The performance level of the apparatus is equivalent to or better
than the performance level required by these standards.
However, the apparatus may be adversely affected by interference
if it is being used in an EMC environment, such as an area where
strong electromagnetic fields are generated (by the presence of
signal transmission towers, cellular phones, etc.). In order to
minimize the adverse effects of the interference on the apparatus in
cases like this, it is recommended that the following steps be taken
with the apparatus being affected and with its operating
environment:
1. Place the apparatus at a distance from the source of the
interference.
2. Change the direction of the apparatus.
3. Change the connection method used for the apparatus.
4. Connect the apparatus to another power outlet where the
power is not shared by any other appliances.
– 2 –
standards
conditions
and operating
to achieving