Publicidad
Idiomas disponibles
Idiomas disponibles
TO A-I-f'ACH
JUMPER
CABLES
-
1.
Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking
care not to short
against
tractor
chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3.
Connect
the other
end of the BLACK
cable
(D) to good chassis
ground,
away from fuel tank and battery.
TO REMOVE
CABLES,
REVERSE
ORDER-
1.
BLACK
cable
first from chassis
and
then from the fully charged
battery.
2.
RED cable
last from both batteries.
Weak or Dead
Fully Charged
Battery
Battery
REPLACING
BA'FrERY
_WARNING:
Do not short
battery
terminals
by allowing
a wrench
or any
other
object to contact
both terminals
at
the same time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands,
rings, etc.
Positive
terminal
must be connected
first to prevent
sparking
from accidental
grounding.
1.
Lift hood to raised
position.
2.
Disconnect
BLACK
battery
cable
(A)
then
RED battery
cable
and carefully
remove
battery
from tractor.
Negative
(Black)
Cable
Positive
(Red)
Cable
4.
First connect
RED battery cable (B) to
positive (+) battery terminal with hex bolt
and keps nutas shown. Tighten securely.
Slide terminal cover (C) over terminal.
5. Connect BLACKgrounding
cableto nega-
tive (-) battery terminal with remaining
hex bolt and keps nut. Tighten securely.
6.
Close hood.
TO REPLACE
HEADLIGHT
BULB
1.
Raise hood.
2.
Remove
bulb holder
from the hole in
the backside
of the grill.
3.
Replace
bulb in holder
and install
bulb
holder
securely
back into the hole in
the backside
of the grill.
4.
Close
hood.
INTERLOCKS
AND
RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring.
See electrical wiring
diagram in the Repair Parts section.
TO REPLACE
FUSE
Replace
with 30 amp automotive-type
plug-in
fuse. The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD
AND
GRILLAS-
SEMBLY
1.
Raise hood.
2.
Unsnap
headlight
wire connector.
3.
Stand
in front of tractor.
Grasp
hood at
sides,
tilt toward
engine
and lift off of
tractor.
4.
When
replacing
hood,
be sure to re-
connect
the headlight
wire connector.
Headlight Wire
Connector
3. Install new battery with terminals in
same position as old battery.
27
Publicidad
