Delivery Contents; Device Description - Aventics EBS-PT Instrucciones De Servicio

AVENTICS | EBS-PT | R412008280–BAL–001–AE | English
Disposal
Dispose of the EBS-PT in accordance with the applicable national
regulations.
3 Applications
The EBS-PT generates a vacuum. Loads can then be picked up
using suction grippers.
The EBS-PT is available in the following variants:
Symbol Designation
EBS-PT-...-DA...-...
1 3
EBS-PT-...- M...-...
2
EBS-PT-...-G...-...
EBS-PT-...-N...-...
4

Delivery contents

The following is included in the delivery contents:
W
1 EBS-PT ejector (with or without silencer)
W
1x operating instructions
Optional accessories:
W
EBS assembly strip
W
EBS silencer
W
EBS adapter
5

Device description

1
Function
The EBS-PT is supplied with compressed air via connection 1. The
compressed air flowing through generates a vacuum at connection
2 and is blown off to the outside via connection 3 (silencer or
exhaust line).
6 Assembly
Improper use
The EBS-PT can be damaged by forceful impacts.
O
Do not forcefully impact the EBS-PT.
O
Use the appropriate tools.
O
Follow the assembly instructions.
Connection design
Push-in fitting
Metric thread
connection
Pipe thread
connection
NPTF thread
connection
CAUTION
Installing and mounting the EBS-PT
Mounting orientation
The EBS-PT can be mounted in any orientation.
Assembling the EBS-PT on the EBS assembly strip
The EBS assembly strip (see "Accessories") enables quick and
easy assembly of all EBS-PT sizes.
The number of EBS-PT ejectors that may be assembled depends
on the size:
Width [mm]
Number of EBS-PT
Individual elements may be separated as needed.
2
Assembling the EBS assembly strip
O
Fasten the EBS assembly strip (1) with at least 2 M4 screws (2),
M = 0.6 Nm and with the washers on the base.
A
4
Assembling the EBS-PT
O
Place the EBS-PT (1) on the EBS assembly strip (2), so that it
audibly engages.
5
Assembling the EBS-PT on a base
O
Make sure that the EBS-PT completely contacts the base and
fastened without any torsion or stress during assembly.
O
Fasten the EBS-PT (1) with at least 2 screws (2) (M4,
M = 0.7 Nm, L = 20 mm) and with the washers on the base.
A
Connecting the EBS-PT
System is operating under pressure
Working on the system when under pressure could lead to
injuries and damage!
O
Depressurize all relevant system parts before working on
the system.
High sound level
High sound levels will occur if the EBS-PT if connection 3
(exhaust) is open during operation. This high sound level can
lead to a loss of hearing over the long run.
O
Only operate the EBS-PT with a silencer or connected
exhaust line.
Use short plastic tubing and small volumes between the
EBS-PT and the suction gripper.
10 15
11 7
CAUTION
CAUTION
6
20
5