Publicidad
Idiomas disponibles
Idiomas disponibles
Stains on load
Gray whites, dingy colors
•
Didyou use enough detergent?
Use enough detergent to remove soil and hold it in suspension.
Add the manufacturer's
recommended
amounts.
•
Did you add fabric softener directly
to the load?
Use your fabric softener dispenser. Do not drip fabric softener
on clothes.
•
Is there above average iron (rust) in water?.
You may need to install an iron filter.
•
Did you properly sort the load?
Sort dark clothes from whites and lights.
•
Did you unload the washer promptly?
To avoid dye transfer, unload the washer as soon as it stops.
•
Did you use a fabric
softener dispensing
ball?
Use the fabric softener dispenser provided with the washer.
Dispensing
balls will not operate correctly with this washer.
•
Did you use powder detergent in a low speed cycle?
Consider using liquid detergent.
•
Did you add detergent, chlorine bleach or fabric softener
too late in the cycle?
Add detergent to your washer before loading the clothes.
Chlorine bleach and fabric softener should be added to the
dispensers before starting the washer.
Load is wrinkled
•
Did you unload the washer promptly?
Unload the washer as soon as it stops.
•
Did you use the right cycle for the load being washed?
Use the Delicate cycle or another cycle with a low spin speed
to reduce wrinkling.
•
Did you overload
the washer?.
The wash load must be balanced and not overloaded. Loads
should move freely during washing.
•
Are the hot and cold water hoses reversed?
Check to be sure the hot and cold water hoses are connected
to the right faucets. (See "Installation
Instructions.")
Did you properly sort the load?
Dye transfer can occur when mixing whites and colors in a
load. Sort dark fabrics from whites and lights.
Was the wash temperature
too low?
Use hot or warm washes if safe for the load. Make sure your
hot water system is adequate to provide a hot water wash.
Did you use enough detergent, or do you have hard
water?
Use more detergent for washing heavy soils in cold or hard
water. Water temperature
should be at least 70°F (21°C) for
soap to dissolve and work properly.
Garment
damage
•
Checkthe
following:
Were sharp items removed from pockets before washing?
Empty pockets, zip zippers, snap or hook fasteners before
washing.
Were strings and sashes tied to prevent tangling?
Were items damaged before washing?
Mend rips and broken threads in seams before washing.
Did you overload the washer?
See "Loading"
for maximum load size.
Did you properly add chlorine bleach?
Do not pour chlorine bleach directly on load. Use your liquid
chlorine bleach dispenser. Wipe up bleach spills. Undiluted
bleach will damage fabrics. Do not place load items on top of
the bleach dispenser when loading and unloading the washer.
•
Did you follow the manufacturer's
care label instructions?
Wash temperature
is not what I selected
•
Are the hot and cold water inlet hoses reversed?
As washing progresses, the wash temperature will decrease
slightly for hot and warm washes. This is normal.
Load is tangled or twisted
•
Did you overload the washer?.
See "Starting Your Washer" for maximum load size. Loads
should move freely during washing.
17
Publicidad
