Descargar Imprimir esta página

Echo PB-7910 H Guia De Inicio Rapido página 6

Ocultar thumbs Ver también para PB-7910 H:

Publicidad

ASSEMBLY / MONTAJE / ASSEMBLAGE
1
T MODEL / T MODELO / T MODÈLE
1C
H
C
G
A
Cable Clip / Clip de cable / Clip de câble
D
Clamp / Abrazadera / Serrer
G
Static Discharge Wire / Cable de descarga
estática / Fil de décharge statique
J
Nozzle Blower Tube / Boquilla Tubo
Soplador / Tube de souffleur de buse
1A. Assemble "T" Model blower tubes:
(a) Assemble Cable Clip (A) onto Clamp (B).
(b) Install Clamp Assembly (A+B) onto upper end of Flexible Blower Tube
(C).
(c) Assemble Clamp (D) onto lower end of Flexible Blower Tube (C).
Note: Before installing Throttle Control (F), allow it to hang freely from
blower to make sure Throttle Cable (L) is not twisted.
1B. Assemble Throttle Control (F):
(a) Position Throttle Cable (L) along outside of Elbow Blower Tube (H).
(b) Loosen Screw Knob (K) and install Throttle Control (F) onto Swivel
Blower Tube (E) as shown. Tighten Screw Knob finger tight only.
1C. Assemble Static Discharge Wire (If Equipped):
(a) Unwrap and fully extend the Static Discharge Wire (G) to insert it
6
Quick Start Guide / Guía de inicio rápido / Guide de démarrage rapide
PB-7910 H/T
1A
B
A
F
C
D
E
K
1D
L
Figure 1 Legend / Figura 1 Leyenda / Figure 1 Légende
B
Clamp / Abrazadera / Serrer
E
Swivel Blower Tube / Tubo de soplador giratorio /
Tube de ventilateur pivotant
H
Elbow Blower Tube / Tubo soplador de codo / Tube
de soufflante coudé
K
Screw Knob / Perilla de tornillo / Bouton à vis
1B
H
B
G
I
J
1E
A
through Flexible Blower Tube (C) as shown in Step 1C.
Refer to Figure1A. again to Assemble "T" Model blower tubes:
Note: A light lubricant can be used to ease the assembly of Flexible Blower
Tube (C) to Elbow Blower Tube (H).
(b) Assemble Flexible Blower Tube (C) to Elbow Blower Tube (H). Position
Clamp Assembly (B) with Cable Clip (A) on outside of Flexible Blower
Tube (C) and tighten Clamp.
(c) Assemble Swivel Blower Tube (E) onto lower end of Flexible Blower
Tube (C) and tighten Clamp (D).
1D. Secure Throttle Cable:
(a) Secure Throttle Cable (L) into Cable Clip (A).
(b) Position Throttle Control (F) to desired position and tighten Screw Knob
(K) hand tight.
F
K
E
I
C
Flexible Blower Tube / Tubo de soplador
flexible / Tube Souffleur Flexible
F
Throttle Control / Control del acelerador /
Commande d'accélérateur
I
Straight Blower Tube / Tubo de soplador
recto / Tube de ventilateur droit
L
Throttle Cable / Cable del acelerador /
Câble d'accélérateur
© 09/2023 ECHO Incorporated X7151200600
L
H

Publicidad

loading

Este manual también es adecuado para:

Pb-7910 t