Mitsubishi Electric TRANE NTXWPH06B112A Serie Manual De Instrucciones página 5

P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
Note:
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low. In about
7 days after the indicator starts lights up, the remote controller stops working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with expired
shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Setting current time
1.
Press CLOCK.
4.
Press CLOCK again.
Note:
• Press CLOCK gently using a thin instrument.
Changing temperature units (°F→°C)
Unit is preset with °F.
1.
Press RESET while
the temperature but-
tons are pressed.
Note:
• Press RESET gently using a thin instrument.
• To change temperature unit from °C to °F, press RESET.
2.
Insert the negative
pole of AAA
alkaline batteries fi rst.
3.
Install the front lid.
3.
Press the DAY button
to set the day.
2.
Press either the TIME button
or the TIMER buttons to set
the time.
Each press changes the clock
1 minute forward/backward (10
minutes when pressed longer).
Setting the installation position
Be sure to set the remote controller in accordance with the installed position of
the indoor unit.
Installation position:
Left: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the left
Center: Distance to objects (wall, cabinet, etc.) is more than 19-11/16 in. (50
cm) to the left and right
Right: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the right
(Left) (Center) (Right)
Area Left
Remote controller
display
1
Hold down on the remote controller for 2 sec-
onds to enter the position setting mode.
2
Select the target installation position by pressing
(Each press of the
order:)
(Center) (Right)
3
Press to complete the position setting.
Note:
The installation position can be set only when all the following conditions are met:
• The remote controller is powered off.
• Weekly timer is not set.
• Weekly timer is not being edited.
Center Right
displays the positions in
(Left)
En-4
.