7. Sleep mode
8. Natural mode
9. Normal mode
Buttons
ON/SPEE D
OFF
MODE
TIMER
SWIN G
On/off button: press the on/off button to switch the fan on or off.
Speed button: press the button to change the speed between low -> medium -> high. Default speed is low speed.
Mode button: press the button to change fan mode between normal mode -> natural mode -> sleep mode. Sleep mode: lowers speed every 30
minutes and then stays at the lowest speed. Natural mode: the speed changes randomly.
Swing button: press the button to activate or deactivate swinging/oscillation. The fan moves slowly from left to right and back again. Oscillation
works in all fan modes.
Timer button: press the button to set a timer between 1 hour to 15 hours and off. Each button press increases the timer with 1 hour. A press after
15 hours turns the timer off. The timer works in all fan modes.
Battery
Before first use: Pull the protective film to remove it. The remote control is now ready for use.
To replace the battery: open the battery compartment on the back of the remote control and replace the used battery with a new one. Battery type:
CR2025.
Maintenance and cleaning
The fan requires little maintenance. If the fan has been broken and requires service, contact qualified personnel.
1. The fan must be disconnected from the mains before cleaning and assembly.
2. To ensure adequate air flow to the fan motor, keep the vents on the back of the fan free of dust. Note: Do not dissemble the fan to remove dust.
3. Wipe the exterior with a soft wet cloth and mild detergent.
4. Do not use abrasive cleaners or solvents to prevent scratching the surface. Do not use any of the following as a cleaner: gasoline, or thinning
solvent.
5. Protect the motor housing and internal parts from water and other liquids.
6. Plastic parts should be cleaned with a soft cloth moistened with mild soap. Wipe clean with a dry cloth.
Features
Power: 220-240V; 50Hz/60Hz, 50W effect
Support
More product information can be found at www.deltaco.eu.
Email: help@deltaco.eu
10