Publicidad
Idiomas disponibles
Idiomas disponibles
R a t e d Ca p a c it y ( S afe Worki ng L oad)
W e i g h t
L o we re d He ig h t
M a x i m u m Hei g ht
OPERATING AND MAINTENANCE INSTRUCTION MANUAL
• STUDY, UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING THIS DEVICE.
• DO NOT EXCEED RATED CAPACITY.
• USE ONLY ON HARD LEVEL SURFACE.
• LIFTING DEVICE ONLY. IMMEDIATELY AFTER LIFTING. SUPPORT THE VEHICLE WITH APPROPRIATE MEANS.
• FAILURE TO HEED THESE MARKINGS MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE.
• LIFT ONLY ON AREAS OF THE VEHICLE AS SPECIFIED BY THE VEHICLE MANUFACTURER.
• NO ALTERATIONS SHALL BE MADE TO THIS PRODUCT.
• ONLY ATTACHMENTS AND/OR ADAPTERS SUPPLIED BY THE MANUFACTURER SHALL BE USED.
• DO NOT MOVE OR DOLLY THE VEHICLE WHILE ON THE JACK.
P R N D 1 2
P R N D 1 2
It is the owner and/or operators responsibility to read and understand all WARNINGS , operating, and maintenance instructions contained on the
product label and instruction manual prior to operation of this unit.
It is also the owner and/or operators responsibility to provide maintenance, maintain all decals or warning labels and in general while in use,
maintain the unit in good working order.
If the owner and/or operator is not fluent in English, French or Spanish, the product warnings and instructions shall be read to and discussed with
the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends its contents.
Your jack has been shipped with a retaining hook to hold the yoke in the downward position. This must be removed.
CAUTION: YOKE IS UNDER SPRING PRESSURE AND COULD POP UP AND CAUSE PERSONAL OR PROPERTY DAMAGE. WEAR EYE
PROTECTION AND GLOVES TO REMOVE YOKE RETAINING HOOK. Push down on the yoke until the block can be removed from between
the yoke and pull rod. A second person may be needed to hold the front of the jack down while applying downward force to the yoke. Remove the
block and allow the yoke to raise to it's upper resting position.
1. Slide the lower handle into the upper handle,
depress the locking button, and slide into the
bottom section until button snaps into hole.
2. Loosen the handle socket screw in the
yoke.
3. Apply a small amount of grease to the
handle socket.
4. Place the assembled handle into the handle
socket.
5. Tighten the handle socket screw.
SPECIFICATIONS
40 00 LB. ( 1 81 4 k g )
58 .7 LB . ( 26 . 6 3 k g )
2- 3/4" (6 . 98 c m)
15 -1/4" ( 38. 73 c m)
P R N D 1 2
OWNER AND/OR OPERATOR RESPONSIBILITY
ASSEMBLY
YOKE RETAINING HOOK REMOVAL
P R N D 1 2
P R N D 1 2
Retaining Hook
1
Press Down
Yoke
Publicidad
