Electrolux Y63IV443 Manual De Instrucciones página 54

glass ceramic is heated by the heat of the
cookware.
The indicators appear when a cooking zone
is hot. They show the level of the residual
heat for the cooking zones you are currently
using:
- continue cooking,
- keep warm,
- residual heat.
The indicator may also appear:
• for the neighbouring cooking zones even if
you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
6.5 Using the cooking zones
Place the cookware in the centre of the
selected zone. Induction cooking zones adapt
to the dimension of the bottom of the
cookware automatically.
You can cook with large cookware placed on
two cooking zones at the same time. The
cookware must cover the centres of both
zones but not go beyond the area marking. If
the cookware is located between the two
centres, Bridge function will not be activated.
54 ENGLISH
6.6 Bridge
The function operates when the pot
covers the centres of the two zones. For
more information on the correct
placement of cookware refer to "Using
the cooking zones".
This function connects two left side cooking
zones and they operate as one.
First set the heat setting for one of the left
side cooking zones.
To activate the function: touch
change the heat setting touch one of the
control sensors.
To deactivate the function: touch
cooking zones operate independently.
6.7 Automatic Heat Up
Use the function to get a desired heat setting
in a shorter time. When the function is on, the
cooking zone operates at the highest heat
setting in the beginning and then continues to
operate at the desired heat setting.
To activate the function the cooking zone
must be cold.
To activate the function for a cooking
zone: touch (
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the heat
setting.
. To set or
. The
comes on). Immediately