Publicidad
Idiomas disponibles
Idiomas disponibles
Installing or Removing Bits (FIG 13)
WArning:
with this drill press or a duplicate of it. This chuck key is self-ejecting and will
"pop" out of the chuck when you let go. This action is designed to help prevent
throwing of the chuck key from the chuck when power is turned "On". Do not
use any other key as a substitute; order a new one if damaged or lost.
To install a drill bit (Fig 13)
1. unplug the drill press.
2. Place the chuck key (1) into the side keyhole of the
chuck (2), meshing the gear teeth (3).
3. Turn the chuck key counterclockwise to open the chuck
jaws (4).
4. Insert a drill bit into the chuck far enough to obtain
maximum gripping of the chuck jaws.
5. Center the drill bit in the chuck jaws before final
tightening of the chuck.
6. use the chuck key for the final tightening to make sure
the drill bit will not slip while drilling.
To remove the bit, reverse the steps listed above.
WArning:
starting any drilling operation.
Application
You may use this drill press for the following applications:
1. Drill in wood.
2. Drill in ceramics, plastics, fiberglass, and laminates.
3. Drill in metals.
WArning:
press before attempting to use it.
Position the Table and Work Piece
Always place a piece of backup material (wood, plywood, etc.) on the table underneath the work
piece This will prevent splintering on the underside of the work piece as the drill bit breaks through.
To keep the material from spinning out of control, it must contact the left side of the column as
illustrated, and be clamped to the table.
for small work pieces that cannot be clamped to the table, use a drill press vise (not included). The
vise must be clamped or bolted on the table.
WArning:
bit before operating the switch to start the tool. Failure to reed this warning
may cause the work piece to be kicked back toward the operator and result in
serious personal injury.
WArning:
starting any drilling operation.
WArning:
clamps or other clamping devices.
8" 5-Speed Drill Press
Operator's Manual
To reduce the risk of injury, only use the chuck key provided
Make sure the chuck key is removed from the chuck before
read and understand the following items about your drill
Always make sure the work piece is not in contact with the
Make sure the chuck key is removed from the chuck before
Always make sure the work piece is secured to the table by
Fig 13
2
4
GDP500
3
1
Publicidad
