GE 22 Manual Del Propietario E Instalación página 18

Installation Instructions
INSTALLING THE WATER LINE
(CONT.)
[] PLUG IN THE REFRIGERATOR
__rranoe the coil of tubing so that it does not xibrate
against tile back of tile refrioerator_ or against, tile
wall. Push the refrigerator back to the wall.
START THE ICEMAKER
Power switch models - Set tile icemaker power
switch to the I (0n) position. The icemaker will
not begin to operate tmtil it reaches its operating
temperature of 15°F (-9°C) or below. It will then
begin operation automatically if the icemaker
power switch is in the I (0n) position, and the
green light will come on.
Power
Switch icemaker
Light
Power switch model
START THE ICEMAKER (CONT.)
Feeler arm models - Move tile feeler
arm
to tile
ON (down)
position. Tile icemaker will not begin to
operate until it reaches its operating temperature
of (l 5 F) (-9 C) or below. It will begin operation
automatically if tile icemaker feeler am_ is in tile
ON (down) position.
Feeler Arminthe
STOP(up)position
Feeler Arminthe ON
(down)position
Feeler arm model
NOTE: In lower water pressure conditions, tile
3 "
water xalxe
IIl_l_ [t/I'II Oil II I) to . tllnes to
delixer
eIlo/vrh
water to the iceinakei;
REVERSING THE DOOR SWING
IMPORTANT NOTES
When re\'e_ing tile door swing:
• Read tile instructions all tile way through before
starting.
• Handle parts careflfllv to avoid scratching paint.
• Set screws down bv their related parts to aw)id using
them in the wrong places.
• Provide a non-scratching work sm'tace tot the doors.
IMPORTANT:
Once vou
begin, do
not Inove tile
cabinet tmtil doo>swi;_g reversal is completed.
These instructions are for changing the hinges fl'om
the right side to the lett side----if you ever want to change
the hinges back to the right side, follow these same
instHIctions and reverse all references to left and fight.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment,
18
TOOLS YOU WILL NEED
Phillipsscrewdriver
Puttyknife or
thin-bladescrewdriver
5/16" Headsocketdriver
3/4" Headsocketdriver
(a 6-pointsocketis
recommended)
Masking tape