EINHELL 3408036 Manual De Instrucciones página 11

4. Technical data
Motor power supply: ................... 18V
No load speed
(3 steps): .................... 1,200 / 1,700 / 2,200 RPM
Max. air speed:........................................ 9.3 mph
Fan size: ........................................................ Ø7"
Weight (Tool only): .....................................2.6 lbs
5. Before starting the equipment
5.1 Fitting the battery (Fig. 4)
Press the pushlock button (13) of the battery as
shown in Fig. 4 and push the battery (12) into the
mount provided (11). Make sure that the pushlock
button engages properly! To remove the battery,
proceed in reverse order!
6. Operation
6.1 On/Off switch (Fig. 3/Item 8)
Switching on:
•
Press the On/Off switch (8).
•
The cordless fan will then come on at the
lowest level.
Switching off :
•
Press the On/Off switch (8) again.
6.2 Adjusting the fan level (Fig. 3/Item 10)
•
The fan has three setting levels for individual
adjustment to a particular situation.
•
The cordless fan always switches on at the
lowest level.
•
To raise the fan level, press on the fan level
selector (9).
•
The fan level will go up one level with each
press.
•
The current fan level is shown by the fan level
indicator (10).
6.3 Adjusting the fan position
•
You can adjust the fan to any position by
turning the fan head.
•
To do so, undo the lock knob (7) on the right-
hand side of the device.
•
Now adjust the fan to the position you want
and retighten the lock knob (7).
Anl_GE_CF_18_2200_Li_SPK7_USA.indb 11 Anl_GE_CF_18_2200_Li_SPK7_USA.indb 11
EN
6.4 Fastening the cordless fan
Using the various recesses in the bottom of the
foot you can quickly fasten the cordless fan in a
, 0.7A
variety of ways.
•
Hook (Fig. 6/Item 6): With the hook you can
fasten the cordless fan quickly and securely
to a handrail, for example, or to scaffolding.
•
Serrated edge (Fig. 7/Item 5): Using the
serrated edge you can hang the cordless fan
on a nail or the like. The fine ribbing is ideal
for balancing the cordless fan.
•
Fastening eyelet (Fig. 8/Item 4): Using the
fastening eyelet and a matching pan-head
screw you can hang the cordless fan on the
wall.
6.5 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.6 Battery capacity indicator (Fig. 5 / item
14)
Press the battery capacity indicator switch (15).
The battery capacity indicator (14) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depthdischarged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
- 11 -
19.07.2023 09:14:04 19.07.2023 09:14:04