Descargar Imprimir esta página

Wasserwerk WK7 Manual página 13

Con rociador extensible para vajilla

Publicidad

• WARNING when set on hot
water supply: Danger of scalding!
• The faucet has an adjustable
hot limit ring.
• Make sure that no caustic or
corrosive agents, such as
cleaning agents or household
detergents get in contact with
the connection hoses, as this
can cause water damage.
• There could be sharp edges,
even with careful production.
Please be careful.
TECHNICAL DATA
• Flow pressure: Recommended
as 1.5 to 6 bar; in case of more
than 6 bar connection pressure,
we recommend that a pressure
reducer is installed.
• Water temperature: max. 60 °C.
INSTRUCTIONS FOR CARE
Sanitary faucets require special
care. Therefore please pay atten-
tion to the following instructions:
• Chrome-plated surfaces are sen-
sitive to agents used to dissolve
limescale, acidic cleaning agents
and all types of abrasive cleaners.
• Coloured surfaces must never be
cleaned with abrasive, caustic or
alcohol-based agents.
• Clean your faucets with clear
water only, using a soft cloth or
chamois.
• Please make sure that the clean-
ers do not enter the cartridge
housing. This can lead to a stiff
operating lever and noises.
Do not forget to unscrew the
mixer jet at regular intervals and
remove any limescale residue or
10955015-01_MA-WK7_SPGB_1222.indd 13
10955015-01_MA-WK7_SPGB_1222.indd 13
foreign bodies. It is recommended
to replace the mixer jet with a new
one if it is very dirty.
MAINTENANCE
• Please note that a cartridge is
a wear part. If the water is very
hard or dirty, you may need to
replace it every 1-2 years
(see page 15).
• Check all connections at regular
intervals for leakage or visible
damage.
• In the event of leakage or visible
damage to the faucet or con-
nection hoses, these should be
checked or replaced immediately
by an expert.
• You can purchase a new car-
tridge from the service centre
indicated.
PULL-OUT DISH RINSER,
DOUBLE ADJUSTABLE
Normal jet
Shower jet
Press
13
02.01.2023 12:57:38
02.01.2023 12:57:38

Publicidad

loading