Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
HOW TO PREPARE THE ENGINE
Fill With Oil
This Edger was shipped with a container of
SAE30 motor oil. Add this oil to the engine
before operating. To fill the crankcase, see
"How To Add The Engine Oil".
NOTE: The engine may contain a small
amount of oil. When adding oil, frequently
insert the oil fill cap/dipstick
and check
the amount of oil in the engine. DO NOT
OVERFILl.
Oil Recommendations
Only use high quality detergent oil rated with
API service classification
SG. Select the oil's
SAE viscosity grade according to your ex-
pected operating temperature.
Above 32 de-
grees, use SAE30 oil. Although
multi-viscosity
oils (5W30, lOW30, etc.) im-
prove starting in cold weather, these multi-
viscosity oils will result in increased oil
consumption
when used above 40 degrees.
Check the engine oil level more frequently to
avoid possible engine damage from running
the engine low on oil.
4
32 °
Colder
_
--Warmer
5W30
SAE30
How To Add The Engine
Oil
1. Put the Edger on a level surface.
2. Remove the oil fill cap (Figure 5).
3. Slowly fill the engine crankcase.
DO NOT
OVERFILL.
How To Fill With Gasoline
Make sure that the gasoline container is
clean and free from dust or other foreign ma-
terial. Never use gasoline that could be stale
from long periods of storage.
1. Remove the fuel cap.
2. Fill the fuel tank with clean, fresh, un-
leaded grade automotive gasoline.
_hlL
ARNING: Always use a safety
fuel container. Do not smoke
when adding the fuel to the en=
gine. When inside an enclosure, do not
fill the fuel tank. Before you add the
fuel, stop the engine. Let the engine
cool for several minutes.
_1
The engine is certified to comply with
California and US EPA emission regula-
tions for ULGE (Utility or Lawn and Gar-
den Equipment) engines. ULGE
engines are certified to operate on reg-
ular unleaded gasoline.
Fuel Cap
Oil Fill Cap
F_021103C
8
Publicidad
