Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the unit in the dashboard
Using the mounting brackets supplied
with your car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.
Example
to dashboard/center console
Bracket
Existing parts supplied
with your car
Note
To prevent malfunction, install only with the mounting
screws .
Setting up the display
The mounting positions of the display can be
adjusted.
Depth
Height
(within 20 mm
(within 60 mm
(
13
/
in), in 3 steps)
(2
3
/
in), in 7 steps)
16
8
Width
(within 25 mm (1 in), in 5 steps)
18
GB
Bracket
Angle
(-10° to +10°, in 3
steps)
Adjusting the depth of the display
position
1
Loosen the 3 pre-installed screws for depth
adjustment (on top and both sides).
Pre-installed screws
Slightly loosen the screws until you can slide the
connector bracket. Do not remove the screws
from the bracket. Doing so may damage the
parts.
2
Slide the connector bracket to decide the
appropriate depth position.
Adjustable depth: within 20 mm (
3 steps, in 10 mm (
13
Bracket positions 1 to 3 for the display:
1: Slide-out position
2: Intermediate position
3: Slide-in position
3
At the desired position, tighten the 3 screws
firmly to secure the connector bracket.
Tighten the screws firmly.
When you tighten a screw, be careful not to
apply too much torque as doing so may damage
the screw (the torque value should be from
1.5 N•m to 2.0 N•m).
13
/
in) (), in
16
/
in) pitch ().
32
3
2
1
Publicidad
