Milwaukee 2524-20 Manual Del Operador página 4

SYMBOLOGY
Volts
Direct Current
No Load Revolutions per Minute (RPM)
UL Listing for Canada and U.S.
C US
SPECIFICATIONS
Cat. No. ..................................................... 2524-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
No Load RPM ................................ 13,050 - 14,500
Max Planing Depth ......................................... 5/64"
Max Planing Width......................................... 2-1/5"
Max Rabbeting Depth ..................................... 7/10"
Recommended Ambient
Operating Temperature ......................0°F to 125°F
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always lock the trigger or remove
WARNING
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
To reduce the risk of injury, always wear proper
eye protection marked to comply with ANSI Z87.1.
Dust from surface coatings such as polyure-
thanes, linseed oil, etc., can self-ignite. Follow the
recommendations of the coatings manufacturers.
Shavings Collection Option
To keep the workplace cleaner, connect to a running
vacuum when using the planer.
1. Switch the shavings diverter to the left or right,
depending on the job.
2. Slide the included shavings collection attachment
onto the planer. Ensure it clicks into place.
NOTE: If you are not using the shavings collection
option, do not run the planer with the shavings
collection attachment installed on the tool.
3. Attach the included vacuum port to the shavings
collection attachment by pushing down on the
lever on the vacuum adapter.
4. Push a vacuum hose (1-1/4", 1-7/8", or 2-1/2"
diameter) onto the vacuum port.
5. To remove the vacuum and adapter, pull the
hose off the vacuum port and push the lever on
the adapter and pull to remove from the shavings
collection attachment.
At the end of each project, clear the shavings ejection
area of all debris.
1. Remove battery pack.
2. Use a non-marring (non-metallic) object to clear
the shavings ejection area of debris, such as the
blunt end of a pen or a pencil.
3. If necessary, use a vacuum to remove any extrane-
ous debris from the shavings ejection area.
Blades are sharp and fragile.
WARNING
Handle with care. Laceration and/
or damage to the blade can occur.
Installing/Replacing Blades
The planer blades have two
cutting edges, and may be
reversed when one of the
cutting edges becomes dull
or chipped. Do not sharpen
planer blades. Always change/
reverse blades in pairs. Use
only 2-1/4", tungsten-carbide
or carbide, double-edged (reversible) planer blades.
Always change/reverse blades in
WARNING
pairs. Unpaired blades can cause
increases in vibration, loss of control, and lower
tool performance.
To remove blades:
1. Remove battery pack.
2. Clean dust and debris from the blade drum.
3. Using the 1/8" hex wrench provided, loosen (do
not remove) the three blade bolts.
4
Blades
Blade
drum
Blade
Hex
wrench
Blade
clamp
Blade
bolts