Publicidad
Idiomas disponibles
Idiomas disponibles
Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A CONFINED
AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death could occur. Always
operate the inflator in a well-ventilated area free of combustible materials, gasoline, or solvent vapors.
Always set parking/emergency brake and ensure vehicle is in Park (or neutral if equipped with manual
transmission).
CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING
NOTICE: ENGINE SHOULD BE RUNNING WHILE USING THIS INFLATOR
It is recommended that you operate your inflator with your vehicle's engine running to achieve
the optimal inflator performance. Never start a vehicle with the inflator plugged into the DC 12
Volt power socket.
• Do not attempt to disassemble inflator.
• No user serviceable parts inside. The only user serviceable part is replaceable fuse.
• Keep inflator out of reach of children.
• Place inflator on a hard, clean surface.
• Ensure air hose chuck touches the core of the valve stem for proper inflation.
• DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool approximately 25 minutes
between uses. Do not leave inflator unattended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inflate.
• Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings. Be careful not to
inflate items beyond their capacity.
• While operating, never block the inflator input or output.
• For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older 8 amp cigarette
lighter receptacles.
NOTE:
Engine should be running while using this inflator. See Warning Section for
further details.
AIR ONLY INSTRUCTIONS
1
1. Select AIR ONLY. NOTE: Lay Flat Tire Repair Kit on the ground facing upward.
2. Screw air/sealant hose onto tire's valve stem.
3. Plug inflator into 12 volt accessory power outlet.
4. Push ON/OFF button to turn system on. Fill to desired pressure.* Press ON/OFF
button to turn system off and check tire pressure. Once correct tire pressure has
been achieved, disconnect air hose and power plug.
*NOTE:
Correct tire pressure can be found in vehicle owner's manual or on driver's
side door jamb.
IMPORTANT! When using the supplied inflatable adapters, the valve
depressor adapter (Fig. A) must be used in conjunction with the inflatable
adapters. Failure to use the supplied valve depressor adapter with inflatable
adapters will result in over-pressurization and failure of the Flat Tire Repair
Kit. To install, remove the valve depressor adapter assembly from the back
of the Flat Tire Repair Kit. Unscrew the Presta valve adapter and set aside.
Thread the valve depressor adapter into the air hose of the Flat Tire Repair
Kit (Fig. B) until fully seated. Thread on the desired inflatable adapter until
snug and inflate item.
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS
EXTREMELY DANGEROUS. ALWAYS ALLOW FOR PROPER
VENTILATION.
3
3
4
4
12v
12v
12V
Fig. A
Fig. B
Publicidad
