Char-Broil 468973023 Instrucciones De Funcionamiento página 5

3
Sear Burner Ignitor Lighting
Ignitor Lighting
• Do not lean over barbecue while lighting.
1. Turn gas burner control valves to (off).
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. To ignite, push and turn burner knob to HIGH. Immediately,
push and hold ELECTRONIC IGNITOR button until the
burner lights.
5. If ignition does NOT occur in 5 seconds, turn the
burner controls off , wait 5 minutes and repeat the
lighting procedure.
6. Repeat steps 4 and 5 to light other main burners.
WARNING
• Turn controls and gas cylinder off when not in use.
• Make sure that when connected hose does not touch
any warm surfaces.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls off, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Match-Lighting
• Do not lean over barbecue while lighting.
1. Turn gas burner control valves to (off).
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. Place match into match holder (hanging from side panel of
barbecue). Light match; then light burner by placing match
through the match light hole on side of barbecue. Immediately
push in and turn burner knob to the HIGH position. Be sure
burner lights and stays lit.
5. Light adjacent burners in sequence by pushing knobs in
and turning to the HIGH position.