JBM 60028 Manual De Instrucciones página 6

NOTE! You must place the guard so that the closed
part always points towards the operator.
Adjusting the wheel guard
1. Pull the quick release lever towards the outside to
enlarge the circular collar.
2. Turn the wheel guard to the desired angle and pull
back the quick release lever to lock the guard.
OPERATION
CAUTION! Never cover the air vents and keep them
open for a proper motor cooling.
Turning On/Off
Slide the On/Off switch forwards to turn the grinder on.
Slide the On/Off switch backwards to turn the grinder
off.
TECHNICAL SPECIFICATIONS
Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DC-20V
No load speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8000 RPM
Diameter of the wheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .125mm
Thread size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M14
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1,54 kg
NOTE! The On/Off switch itself is also a safety lock bu-
tton. If you slide the switch forward, press it downwards
on its front and release it, the switch automatically loc-
ks.
Operating instructions
• In general, keep the edge of the wheel at an an-
gle of about 30° for roughing and about 15° for
finishing.
• Do not overload. Only apply the necessary pres-
sure to avoid the grinder to bounce.
MAINTENANCE
• Keep the cutting tools sharp and clean.
• Periodically check the grinder for misalignments or
broken parts.
• Keep the angle grinder and its handle dry, clean
and free from oil and grease.
• Do not use cleaning products that may damage
plastic parts such as petroleum-based products or
any strong solvent.
• Clean the air vents only with compressed dry air
regularly.
• Only professional personnel must perform tool
maintenance.
NUM.
1
2
3
4
5
6
7
8
9
10
11
12
· 6 ·
DESCRIPTION
Auxiliary handle
Spindle lock button
On/Off switch
Quick release lever
Wheel guard
Grinding wheel
Release button
Battery Pack
Charger
Inner flange/Disc flange
Outer flange/Lock nut
Wrench
REF. 60028