Worx WX045.X Manual Original página 12

4. OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The tool can be used for bonding wood, leather, plastics ,papers and other
materials.
OPERATION
Inserting or removing the battery pack
Charging the battery pack
Insert the glue stick into the glue stick hole
Press the ON/OFF switch for 3 seconds.
The heat indicator light will be red as it heats and will turn green
when it is ready to use.
Press the switch trigger for gluing
NOTE: It is recommended to apply the glue on large surfaces
EN
or long work pieces in the form of points. On flexible materials,
12 apply in lines.
WARNING: Do not allow the hot glue or the nozzle tip
to come into contact with persons or animals.If hot
glue contacts with the skin, do not try to remove the glue
from the skin,but put the affected area immediately under a
stream of cold water for several minutes.
5.MAINTENANCE
Remove the battery before carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust. Occasionally you may see sparks
through the ventilation slots. This is normal and will not damage your power
tool.Store the accessories in a dry place.
Warning: Do not use inflammable solvents for cleaning the surfaces to be
glued. For excess hardened glue, it can be removed with a blunt object. Do
not use solvent for cleaning.
ACTION FIGURE
See Fig. A
See Fig. B
See Fig. C
See Fig. D
See Fig. E