Publicidad
Idiomas disponibles
Idiomas disponibles
Blower Motor System Installation
The internal blower system can be mounted for top
venting. The mounting bracket and spring clip that
comes with the blower system will mount to the top
panel of the hood insert.
Intemal Blower System Installationinto Hood Insert
IMPORTANT."Perform steps 1-10 before mounting the
hood insert into the cabinet.
NOTE: Mounting hardware is included with the Blower
Motor System.
1.
Remove grease filters from hood insert.
2.
Install the motor support bracket using three 4.2 x
8 mm screws. Screw bracket to the inside top,
toward the leftside of the hood insert(seestep 2 figure).
3.
Install motor spring clip using two 4.2 x 8 mm
screws. Screw spring clip to the inside top of the
hood insert at the proper location for the selected
motor system. Slide the mounting tab of the
spring clip through the slot in the panel and secure
with the screws (see step 3 figure).
4.
Install the 6 mm clip nuts to the outside top
of the hood insert at the proper location for the
selected motor system.
•
Two 6 mm nuts are required for 600 CFM
(single motor) Blower Motor Assembly.
Clip nuts into the small square notches
located at the left and right end of the
square vent opening.
•
Four 6 mm nuts are required for 1200 CFM
(dual motor) Blower Motor Assembly. Clip
nuts into the small square notches, located
at the left and right ends of the square vent
opening.
//
!fX
"""
A. 6mm Clip Nut
/ill
_i,x_
l"_
B. Clip nut locations for single motor assembly (2)
_
%_ _"
C. Clip nut locations for dual motor assembly (4)
/
\
/
/
/
\
/
/
\
/
\
/
\
B
5.
Install the hood insert blower motor assembly
inside the hood insert canopy with the wiring
connection to the left for the single motor system
and to the front or top for the dual motor system
Single Blower Motor Assembly
STEP 2
A. 4.2 x 8 mm screws (3) for motor support bracket
B. 4.2 x 8 mm screws (2) for motor spring clip
C.Motor support bracket
D.Motor spring clip (single motor assembly location)
E.Motor spring clip (dual motor assembly location)
E Terminal Box
* In model EI30HI55KS is located on the right side
A
A.Wiring connection
©
©
Publicidad
